Lubricating The Wheel Kit Cylinder Pivots - Husqvarna Wacker Neuson CRT60-74LX Operator's Manual

CRT60-74LX
6.15

Lubricating the Wheel Kit Cylinder Pivots

Requirements ■ Machine stopped
■ Grease (Unirex N2 or equivalent)
Procedure Perform the procedure below to grease the front wheel kit cylinder pivots.
1. Set the trowel on a flat, level surface.
2. For access, raise the wheel kit.
3. Disconnect the battery.
4. Remove the six screws (a) holding the access panel (b).
a
b
5. Lift off the access panel.
6. Apply grease to each zerk (c) on the front wheel kit cylinders (d).
7. Install the access panel with six screws.
Perform the procedure below to grease the rear wheel kit cylinder pivots.
1. Locate each zerk (e) on the rear wheel kit cylinders (f).
2. Apply grease to each zerk on the rear wheel kit cylinders.
3. Connect the battery.
wc_tx004561gb.fm
c
e
79
Maintenance
d
c
wc_gr012747
f
e
wc_gr012748