Husqvarna Wacker Neuson CRT60-74LX Operator's Manual page 63

CRT60-74LX
Continued from the previous page.
4. There is a small amount of play in the connection between the blade arm and
the spider (lift plate). Gently wiggle each blade so that the lower end of the blade
is at the lowest point of the play. Mark (c) the fork pocket at the location where
you will measure. Then, measure the distance (x) from the bottom of the fork
pocket to the bottom edge of the blade. Measure the distance (x) for each blade.
Note: You can rotate the blades by hand, however, only in one direction.
5. Determine the average distance "x". Adjust any blade that does not measure
the distance "x" ± 1.25 mm (0.050 in.). To adjust a blade, loosen or tighten the
pitch links (d) as necessary.
wc_tx004561gb.fm
63
Maintenance
c
x
wc_gr012738
d
wc_gr012739