Changing The Steering Mode - Husqvarna Wacker Neuson CRT60-74LX Operator's Manual

Operation
5.8

Changing the Steering Mode

The steering mode button (u) allows the operator to change the response of the
joysticks depending upon the intended machine movement or concrete surface
condition. Press the steering mode button to change between the two response
modes. The instrument display screen shows either a 1 for high resolution mode or
a 2 for high rate mode.
Modes
Mode
High Resolution
High Rate
Machine response
This is the standard response mode.
In this mode, larger movements of
the joysticks are required to control
machine motion.
(t)
The LED illuminates when in this
mode.
This is the increased response
mode. In this mode, smaller
movements of the joysticks are
required to control machine
movement.
48
CRT60-74LX
t
u
wc_gr014516
Recommended use
Intended for use when edging,
finishing around poles, or
operating on extremely sticky
surfaces.
Intended for use when
panning, traveling at high
speeds, or when minimum
directional control is required
while covering large areas.
wc_tx003645gb_FM10.fm