Panasonic CF-19ADUAX M Series Service Manual page 68

■ Cautions for Setting the Keyboard
S1: S2:
S4: S5:
S1:Insulation S2:Pinching Cables
CAUTION
S3:Sharp Edge S4:Check Parts NO. S5:Others
Insert positions of
LCD Cable/Keyboard FFC
Insert the Connector
to the dotted part.
S5 Safety work
*Note: To avoid wiring damage
Hold the Connector
part when
connecting/
disconnecting.
Never bend at
the bottom of
the Stiffening
Plate.
Insert position
of Keyboard FFC.
Insert the LCD Cable.
Tilt to the right side Tilt to the right side Tilt to the right side
and process. and process. and process.
Avoid running Avoid running Avoid running
over the Top over the Top over the Top
Case. Case. Case.
Insert the Keyboard FFC.
Lock the Lock the Lock the
Connector after Connector after Connector after
inserting FFC. inserting FFC. inserting FFC.
S3:
KBD CNT Lid Ass'y
Use the jig.
Apply the load
to attach:30~40N to attach:30~40N to attach:30~40N
(3.0~4.0Kgf) (3.0~4.0Kgf) (3.0~4.0Kgf)
Confirm the LCD
Rear side comes
front when processing
the wire.
Screw(N1)
Screw(N1)
Safety work
S2
Insert the Insert the Insert the
Keyboard FFC. Keyboard FFC. Keyboard FFC.
Keyboard Ass'y
Set using the jig.
<Screw tightening torque>
Screw(N1,N9) = 0.2 ± 0.02N·m ( 2.0 ± 0.2kgf·cm)
<Screw tightening order>
Screw(N1)
The cushion protrudes
from the edge of the Lid.
KBD
CNT Lid
KB CNT Lid WP Sheet KB CNT Lid WP Sheet KB CNT Lid WP Sheet
After setting the KBD,
rotate the LCD so the
LCD display faces front.
Screw(N1)
Keyboard Plate(L)
KBD CNT
Lid Ass'y
Screw(N9)
7-46
Attach to the inside
the groove.
Avoid running over.
Gasket
Gasket Gasket
Screw(N9)
Fix from the
Hinge side.
Screw(N9)
Screw(N9)
Before attaching Before attaching Before attaching
Keyboard Plate(L) Keyboard Plate(L) Keyboard Plate(L)
and Keyboard and Keyboard and Keyboard
Plate(R), apply Plate(R), apply Plate(R), apply
pressure on the pressure on the pressure on the
two-sided Tape parts two-sided Tape parts two-sided Tape parts
(4 positions). 30N (3.0Kgf) (4 positions). 30N (3.0Kgf) (4 positions). 30N (3.0Kgf)
4~7mm
Screw
(N9)
Keyboard
Plate(R)