Panasonic CF-19ADUAX M Series Service Manual page 59

■ Line Processing of Antenna Cable
S1: S2:
S4: S5:
S1:Insulation S2:Pinching Cables
CAUTION
S3:Sharp Edge S4:Check Parts NO. S5:Others
Cable Process 1/3
Step1
Process the Cables
(Blue, Gray and Green)
in the arrow A direction.
Step2
Pass Blue, Gray and
Green Cables through
under the FFC of the
Audio PCB.
Audio PCB Audio PCB Audio PCB
0 2mm 0 2mm 2mm
2~5mm
After processing the Cables,
Insulation Parts
inserting the FFC and locking,
Fix the Blue and
incline the Audio PCB into the
Gray Cables with
arrow direction.
the Tape.
Cable Process 2/3
Step7
<Screw tightening torque>
Screw(N41) = 0.2 ± 0.02N·m ( 2.0 ± 0.2kgf·cm)
<Screw tightening order>
→ →
Screw(N41) =
S1: S2:
S4: S5:
S1:Insulation S2:Pinching Cables
CAUTION
S3:Sharp Edge S4:Check Parts NO. S5:Others
S3:
Step3
Process the Cables
(White and Black)
in the arrow B
direction.
A
B
Step4
Insert the FPC. Insert the FPC. Insert the FPC.
Check Locking. Check Locking. Check Locking.
<Screw tightening torque>
Screw(N41) = 0.2 ± 0.02N·m ( 2.0 ± 0.2kgf·cm)
<Screw tightening order>
Screw(N41) =
Connect the gray Connect the gray Connect the gray
Antenna Cable. Antenna Cable. Antenna Cable.
S3:
Confirm the Cables processed in
Step 5 do not exist under the Audio
PCB, and then fix the Screws.
S2 Safety work
This is because Cable catching may
occur between the PCB and Boss.
Screw(N41) Screw(N41) Screw(N41)
Screw(N41) Screw(N41) Screw(N41)
Fix the Audio PCB. Fix the Audio PCB. Fix the Audio PCB.
Screw(N41)
Process the Cable as shown
and connect the Cable (Black).
→ →
Step8
Safety work
S2
Step9
Screw(N41)
7-37
Step5
Process the Cable as
shown and connect the
Cable (White).
WLAN Coaxial
Step6
Cable
Connect the blue Connect the blue Connect the blue
Antenna Cable. Antenna Cable. Antenna Cable.
Insert into the Clamper.
If poorly fixed, If poorly fixed, If poorly fixed,
the Cable catching may occur the Cable catching may occur the Cable catching may occur
between the Board and Boss. between the Board and Boss. between the Board and Boss.
Screw(N41)
Screw(N41)
Process the
additional
Cable (Gray).
Connect FFC.