Table of Contents
Advertisement
■ Assembly of LCD Unit Ass'y - 2
S1:
S2:
S4:
S5:
S1:Insulation S2:Pinching Cables
CAUTION
S3:Sharp Edge S4:Check Parts NO. S5:Others
S5
Safety work
Details of "A"
Ensure the edge of the
conductive Tape is not
frayed to avoid short
circuit with the Board.
LCD Cable
S1:
S2:
S4:
S5:
S1:Insulation S2:Pinching Cables
CAUTION
S3:Sharp Edge S4:Check Parts NO. S5:Others
Connector edge ±1mm
S2
Safety work
Avoid catching the Speaker Cable.
Avoid running over the Speaker Cable.
Pass the LCD
Cable as below.
S3:
LCD Conductive Tape
Wrap around
the LCD Cable
with two or three
rotations and attach.
S3:
Insert between the ribs.
LCD Side Cushion Upper
PCB Edge Sheet
Attach firmly
on the Connector.
Connector
bottom edge
±1 mm
Insert into the
Connector.
Fold the Tape as
Attach the Tape
below to attach.
as below.
Pet Tape
Corner
Corner
Corner
±1 mm
±1 mm
±1 mm
*Avoid running over
the waterproof rib
of the LCD Front.
Before attaching
Attach as it comes into contact
with the Steel Plate on the side
surface.
Attach firmly to avoid
FPC coming off.
Tape
FPC
PCB
Connector
Insert TS FPC and attach
the Sheet as above.
Attach as covering the PCB.
LED PCB
*Attach the shaded part
INS Sheet
firmly to the Plate.
PET Tape
Insert into
Insert into
Insert into
the Connector.
the Connector.
the Connector.
Avoid any stress on the TAB
part of the LCD Module because
the line comes off.
LCD Cable Cushion
Match to
the red line.
0 1mm
5~7mm
Fold back and twist
Attach the Cushion
around the Cable to
as shown.
attach.
7-16
After attaching
0~0.5 mm from the
positioning rib end.
EMI Sheet
0~0.5 mm from
the LCD Frame end
Completion
Insert between the ribs.
LCD Side Cushion Upper
Attach it on the Connector.
Attach it on the Connector.
Attach it on the Connector.
LCD Side
Cushion Left
Insert between
Insert between
Insert between
the ribs.
the ribs.
the ribs.
After wrapping around the Cable, insert into
the Cabinet. The cushion must come within
±2mm from the center of the rib.
Apply pressure
on the
attached part.
Attach the remaining
part as twisting around
the Cable. Complete
Advertisement
Table of Contents
