Panasonic CF-19ADUAX M Series Service Manual page 41

7.2.4. Setting up the Hinge Ass'y
1. Set the 2 Cable Holders.
2. Set the Hinge Ass'y and Cable Hold Plate.
3. Fix the Hinge Ass'y and Cable Hold Plate using the 2
Screws <N17>.
■ Assembly of Hinge
Initial state of Hinge
<Screw tightening torque>
Screw(N17) :0.8 ± 0.08N·m ( 8.0 ± 0.8kgf·cm)
Cable Hold Plate Cable Hold Plate Cable Hold Plate
Screw(N17)
Avoid running over the rib
and boss to avoid catching
the Cable when the Hinge is set.
Hinge
Cable Hold
Screws <N17> : DXYN3+J8FNL
If attached reversely,
the direction of cutting
edge faces the Cable
and this may damage
the Cable. Be careful
of the direction.
Safety work
S3
Ensure the "C" side comes
to the lower right corner
when viewing from above.
S2
Screw(N17)
CAUTION
7-19
Cable
<N17>
Hold
<N17>
Plate
Hinge
Ass'y
Plate
Using the fixing jig
when fixing the Hinge
Tighten
If you arrange the Cable
in the area, you do not
need to use the fixing jig.
S1: S2: S3:
S4: S5:
S1:Insulation S2:Pinching Cables
S3:Sharp Edge S4:Check Parts NO. S5:Others
Cable
Holder
Cable
Holder
Tighten
Fix.