Panasonic CF-19ADUAX M Series Service Manual page 53

■ Preparation of Main PCB
S1: S2:
S4: S5:
S1:Insulation S2:Pinching Cables
CAUTION
S3:Sharp Edge S4:Check Parts NO. S5:Others
Match to the silk and
attach Coin BAT Sheet.
0~0.5mm
0~0.5mm
Coin BAT Sheet Coin BAT Sheet Coin BAT Sheet
Match to the silk Match to the silk Match to the silk
and attach. and attach. and attach.
Coin Battery Coin Battery Coin Battery
Process the Cable
on the Coin Battery.
S3
Safety work
<Screw tightening torque>
S3:
Screw(N1) :0.19 ± 0.02N·m (2.0 ± 0.2kgf·cm)
<Screw tightening order>
→
Screw(N1)
Attach as covering the Attach as covering the Attach as covering the
Connector and the Cable. Connector and the Cable. Connector and the Cable.
Protect Sheet Protect Sheet Protect Sheet
DIMM Ass'y
Modem
Module Ass'y
1394 Connector
Screw(N1) Screw(N1)
Back
side
Screw(N1)
Avoid running
over the land
of Chip parts.
DIMM Slot DIMM Slot DIMM Slot
Match to
the silk.
0~0.5mm
Attach DIMM Cushion
before attaching DIMM Ass'y.
Match to the end.
0~0.5mm
7-31
Attach both sides
Tape
to the both lateral
sides.
0±1mm 0±1mm 0±1mm
As for longer direction, As for longer direction, As for longer direction,
match to the center of match to the center of match to the center of
the Connector with ±3mm the Connector with ±3mm the Connector with ±3mm
and attach. and attach. and attach.
Ensure that the attaching direction
is right. Ensure that it does not run
over the copper foils (red dotted
part) that support the die and boss.
CPU Insulation Sheet CPU Insulation Sheet CPU Insulation Sheet
0±0.5mm 0±0.5mm 0±0.5mm
0±0.5mm
DIMM Cushion DIMM Cushion DIMM Cushion
Match to the silk.
0~0.5mm
Match to the end.
0~0.5mm
Tape