Panasonic CF-19ADUAX M Series Service Manual page 47

■ Assembly of Display Unit
<Screw tightening order>
Details of "A"
black
White
Set to the Top Case Ass'y. Set to the Top Case Ass'y. Set to the Top Case Ass'y.
A A
LCD Cable
Apply tension to the Cable so it does
not sag inside the Hinge Cover.
<Screw tightening torque>
Screw(N18) :1.5 ± 0.15N·m ( 15.0 ± 1.5kgf·cm)
Screw(N1)
Fix from the round hole.
LCD Hinge Cover LCD Hinge Cover LCD Hinge Cover
<Screw tightening torque>
Screw(N9) :0.2 ± 0.02N·m ( 2.0 ± 0.2kgf·cm)
*Note
Avoid excessive stress on the Cable.
Pass the Cable through
the groove of the Cushion.
(1 Cable for 1 groove)
Caution: Running over affects
waterproof performance.
glay
Green or Yellow
blue
LCD Unit
Insert all Antenna Cables into
the notch of the Board.
LCD Cable
Insert Position
Rotate the LCD to
the arrow direction
so the LCD display
faces inside.
Screw(N9)
Screw(N18)
Close the LCD with Close the LCD with Close the LCD with
the Hinge hooked the Hinge hooked the Hinge hooked
on the Top Case, on the Top Case, on the Top Case,
and then fold back. and then fold back. and then fold back.
Screw(N1)
Fix from the round hole.
Screw(N9)
7-25
Screw(N18)
Screw(N18)
Screw(N18)
Rotate the LCD to
the arrow direction
again so the LCD
display faces outside
(tablet condition).