Panasonic CF-19ADUAX M Series Service Manual page 58

■ Preparation of Sub PCB
*Notice
·Arrow part without specified measurement: 0~0.5 mm
<Screw tightening torque>
Screw(N3, N5) = 0.2 ± 0.02N·m ( 2.0 ± 0.2kgf·cm)
*Use an electric driver with low impact for Screw(N5).
IO PCB Ass'y
FFC(IO)
Lock the Connector
after inserting it.
IO PCB
PR PCB Ass'y
PR PCB
DU CNT Angle
Screw(N3)
EXT ANT PCB
Screw(N3)
■ Assembly of RF-IF PCB and BT PCB
RF-IF PCB Ass'y
<Screw tightening torque>
Screw(N19) = 0.2 ± 0.02N·m ( 2.0 ± 0.2kgf·cm)
<Screw tightening order>
→ →
Screw(N19) =
Apply the lubricant (sub material)
on the Battery Connector for about
1 second. (Be careful about
spraying around when applying.)
PORTRE Sheet Avoid running over the end
of the PCB by 0.5 mm or
more.
Screw(N3)
Back side
Screw(N3)
ANT Cable Holder ANT Cable Holder ANT Cable Holder
Fit into the Plate Fit into the Plate Fit into the Plate
before attaching before attaching before attaching
the PCB. the PCB. the PCB.
RF-IF PCB Ass'y
Lock the Connector Lock the Connector Lock the Connector
after inserting it. after inserting it. after inserting it.
FPC(HSDPA)
Screw(N19)
→ → →
<Screw tightening order> Screw(N3) =
BAT CON Angle Ass'y
BAT CON Angle
0~0.5mm
Attach to the Attach to the Attach to the
Connector before Connector before Connector before
Ass'y. Ass'y. Ass'y.
BAT Insulation Sheet BAT Insulation Sheet BAT Insulation Sheet
0~1mm
Glue part Glue part Glue part
RF-IF PCB
Attach matching
to the upper shape
of the Connector.
RF-BT Plate
Screw(N19)
Screw(N19)
Screw(N19)
Insert into the hole
of PCB as below.
Clamper Clamper Clamper
7-36
→ → →
0.5~1.5mm
BAT Cushion
Screw(N5)
Gasket
0~1mm
0~2mm
FPC(Battery)
BAT CON Holder
SD-LAN
0±0.5mm
PCB
Ass'y
0±0.5mm
0~1mm 0~1mm 0~1mm
FPC(SD LAN)
Lock the Connector Lock the Connector Lock the Connector
after inserting it. after inserting it. after inserting it.
Screw(N19)
FFC(BT)
Insert
SD PWD SD PWD SD PWD
INS Sheet INS Sheet INS Sheet
Back
side
SD-LAN PCB
Insert
Addition
LAN Cable
Screw(N19)
BT PCB