Preparations Before Filling - Wexiodisk WD-4S Installation And User Manual

Operating instructions
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
In the following chapter, figures are given in brackets to clarify what needs to be
done. These numbers refer to image and list above.

4.1.2 Preparations before filling

Check:
•
•
•
•
•
•
Remember:
•
•
•
•
•
•
WD-4S
Button for programme P1
Button for programme P2
Button for programme P3
Display
Button for changing water
Button for emptying machine with internal cleaning
Button for ON/OFF. Acknowledgement of alarm, green LED for "ready for
wash" and faint red LED when the machine is switched off. Flashes yellow
in the event of IF alarm and red for Er alarm.
Indicator which, among other things, counts down the washing time
Tank strainers (x 2)
Drain filter
Pump filter
Washing arms (x 2)
Rinse pipe (x 4)
Active filter (located under the tank strainers) (option)
That the machine and removable parts have been cleaned. If not – clean
them!
that no dirt is in the washer arms' (12) or in the rinse pipes' (13) nozzles
That removable parts are correctly in place
The amount of detergent and drying agent (option)
That the stopcock for the water to the machine is open
That the power switch is in the ON position
Ordinary washing-up liquid must not be used in the machine or for soaking.
Contact your detergent supplier regarding the choice of a suitable deter-
gent. Washing-up liquid causes a build-up of foam, produces poor wash re-
sults and can damage the machine.
Steel wool must not be used for pre-treating the dishware.
Only detergent and drying agent intended for industrial machines may be
used.
If using liquid detergent and drying agent, the same make and type of de-
tergent and drying agent should be used.
If the machine is designed for glass washing and equipped with a condens-
ing unit, detergent intended for aluminium should be used.
If the machine is equipped with a condensing unit, dishware should be re-
moved from the machine as soon as the condensation cycle is complete so
that re-condensation does not occur.
26
Rev. 5.0 (201912)