Ventilation; Detergent And Drying Agent - Wexiodisk WD-4S Installation And User Manual

Installation instructions

3.5.4 Ventilation

The machine's heat load for the room is stipulated in TECHNICAL SPECIFICA-
TIONS.

3.5.5 Detergent and drying agent

•
•
•
•
•
•
If equipment for a different type of detergent is used, it should preferably be put
on the wall behind the machine to avoid holes being drilled unnecessarily in the
machine.
The process of setting the detergent and drying agent dispenser is described in
the ADJUSTMENT INSTRUCTIONS.
For information about electrical connections, see the electrical diagram.
A
The detergent (A) is placed below the door's (B) bottom edge.
If the machine is equipped with stand (C), the detergent can be placed there.
WD-4S
Check what your machine is equipped with, which depends on the model,
machine type and country.
The bushing for hoses is located on the rear of the machine.
Use the same make and type of detergent and drying agent.
With machines connected to cold water, the water pipe temperature may
be too low for use of powder or paste type detergents.
If liquid detergent is used together with Wexiödisk's detergent pump, the
detergent must be placed under the machine's tank level.
As the machine is equipped with a condensing unit, detergent intended for
aluminium should be used. Washed items should be taken out of the ma-
chine as soon as the condensation cycle is complete so that re-condensa-
tion does not occur.
B
19
Rev. 5.0 (201912)
B
C
WD-4S_06