Table of Contents
Advertisement
Installation instructions
3.5.2 Water connection, regardless of any options
•
•
The water pipe is connected at (1). The machine should be connected with a steel
braided and flexible hose. The hose's internal diameter should be at least 9 mm.
It can be helpful to use the connection hose WD400125.31.
The water connection on the machine is fitted with a filter, non-return valve and
vacuum valve.
3.5.3 Drain/waste pipe
The drain/waste pipe connection consists of a spiral hose that is provided on de-
livery.
Ensure that the drain connection is kept in place by using e.g. cable ties in the
designated areas.
A=drain hose
B=floor drain
Connect the drain/waste hose (A) to the floor drain (B) according to one of the op-
tions in the illustration.
WD-4S
A shut-off cock must be installed on the incoming pipe.
It is important that the water supply has sufficient pressure to ensure the
correct flow of water to the machine. The required water flow and pressure
can be found in the TECHNICAL SPECIFICATIONS. If the water pressure
is too low, a booster pump must be fitted.
avlopp_dp
18
Rev. 5.0 (201912)
A
B
min. 25mm
Hide quick links:
Advertisement
Table of Contents
