Table of Contents
Advertisement
Deployment
Counter additional functions
4.5 Counter additional functions
Overview
Schematic structure
Gate function
52
The following additional functions may be set for each counter via the parameterization:
n
Gate function
–
The gate function serves for the start, stop and interrupt of a count function.
n
Comparison
–
You may set a comparison value that activates res. de-activates the digital output
res. releases a process interrupt depending on the counter value.
n
Hysteresis
–
The setting of a hysteresis avoids for example a high interrupt toggling when the
value of an encoder signal shifts around a comparison value.
The illustration shows how the additional functions influence the counting behavior. The
following pages describe these functions in detail:
The activation res. de-activation of the counter happens via an internal gate (I gate). The I
gate corresponds to the software gate (SW gate). The SW gate is opened (activated) via
your user application by an edge 0-1 of the bit SW_GATE_SET of the control word in the
output area. The software gate is closed (de-activated) by an edge 0-1 of the bit
SW_GATE_RESET. If the I gate was automatically closed at "counting once", so this may
only be opened with an edge 0-1 on SW_GATE_SET. The following states influence the I
gate:
SW gate
0
1
with edge 0-1
Gate function abort and interrupt
VIPA System SLIO
influences
I gate
0
1
1
HB300 | FM | 050-1BB00 | en | 19-38
Advertisement
Table of Contents
