6 Connecting The Unit; Opening And Closing The Housing; Removing And Attaching The Rear Panel - Henny Penny FlexFusion ELECTRIC SPACESAVER PLUS FSE-610 Installation Manual

Connecting the unit
6 Connecting the unit
DANGER
CAUTION
NOTICE

6.1 Opening and closing the housing

6.1.1 Removing and attaching the rear panel

NOTICE
24
Risk of personal injury and property damage from electric shock
• Before working on the unit, ensure that the unit is dead.
• Do not operate the unit with the housing open.
Risk of injury from sharp edges
• Wear protective gloves.
Risk of property damage from damage to the lines
• Remove and attach housing components carefully.
Remove the rear panel.
A
Image: Remove the rear panel, A Tabletop unit, B Built-in unit
1. Unscrew the screws in the back wall.
2. Holding the bottom edge, carefully pull the back wall down and
then forward.
Attaching the rear panel
Risk of property damage from leaky housing
• Check seals when attaching the housing parts.
• Replace damaged seals.
Installation instructions
B