Henny Penny FlexFusion ELECTRIC SPACESAVER PLUS FSE-610 Installation Manual page 27

CAUTION
CAUTION
regulations, standards and guidelines must be observed, as well as the
connection conditions imposed by the electric utility company
responsible.
Technical qualifications for electrical installation tasks
Electrical installation tasks on the electrical system and the unit may be
carried out only by an electrician provided by the specialist company
contracted.
The unit must be connected in accordance with the information on the
nameplate and the instructions of this manual.
Wiring diagram
The wiring diagram is included with the unit.
The wiring diagram and additional documents are available on the
manufacturer's Internet page by entering the serial number of the unit
(see Imprint).
Electrical connection line
Minimum requirements for the unit's electrical connection line to the
electrical supply mains:
Connection
Permanent connection for fixed
installation with a cable from the unit to
a separate connection box.
Connection of the unit with a connector.
Permanent connection
Risk of property damage and personal injury from improper instal-
lation
• In the case of a permanent connection, install an all-pin separating device
before the unit.
Install an all-pin separating device if the unit will be connected
permanently to the electrical supply mains.
Plug-in connection
Risk of property damage and personal injury from improper instal-
lation
• The plug-in connection must be readily accessible.
If the unit is connected with a plug to the electrical supply mains, use
plugs and sockets according to IEC60309.
The socket must be readily accessible so that the unit can be
disconnected from the electrical supply mains at any time.
Installation instructions
Connecting the unit
Electrical connection line
Rubber sheath cable, oil-resistant,
shrouded and flexible in accordance
with IEC 60245-57 (for example:
H05RN-F).
27