Henny Penny FlexFusion ELECTRIC SPACESAVER PLUS FSE-610 Installation Manual page 9

Installation Risk of property damage and personal injury from improper
Electrical connection Risk of fire from improper connection
Unit on casters Danger of a line breaking if subjected to high tensile load
Commissioning Risk of property damage and personal injury from improper
installation
• Wear safety shoes and protective gloves.
• Observe applicable regional regulations of the electric supplier.
• Ensure that only electricians licensed by the electric supplier
connect the unit.
• Ensure that the electrical system is earthed by a protective
earthing conductor.
• Note the information on the nameplate.
Danger of electric shock from live components.
• Prior to working on the electrical system, switch off the unit,
disconnect the electrical system from the mains and prevent
power from being switched on again. Check to ensure the system
is dead.
• Use only insulated tools.
• Using a chain to provide strain relief for the connection lines,
secure the unit at the installation site so that the connection lines
are not put under tension when the unit is moved. The strain relief
must be designed for a tensile load of at least 0.6 kN.
commissioning
• Read the operating instructions prior to commissioning. Observe
the safety instructions in these installation instructions and in the
"Safety information" chapter of the operating instructions.
• Only put the unit into service after a successful function test in its
assembled state.
• Put the unit into service only after it has reached room
temperature.
• Observe the units during operation.
Installation instructions
Safety instructions
9