Prerequisite Floor capable of accommodating the weight of the unit
Floor must be clean and suitable for the manner fastening
Unit set up and aligned in accordance with the planning drawing
1. Insert the floor plate from the fastening kit into the retainer as
shown in the drawing.
2. Screw on the cap nuts hand-tight.
3. Align the floor fasteners in position 1-1 or 2-2 on the unit leg or
underframe as shown in the drawing and mark the floor.
4. Screw on cap nuts and remove the retainer from the floor plate.
5. Using the adhesive provided, fasten the floor plates to the floor.
6. Place retainers on the floor plates and secure using cap units.
7. Complete the start-up operation report.
Follow the manufacturer's instructions regarding the adhesive.
Apply the adhesive in accordance with the manufacturer's
instructions.
Observe the drying time specified in the manufacturer's
instructions.
Installation instructions
Installing the unit
23