5 Installing The Unit; Minimum Clearances - Henny Penny FlexFusion ELECTRIC SPACESAVER PLUS FSE-610 Installation Manual

Installing the unit
5 Installing the unit
CAUTION
CAUTION
NOTICE

5.1 Minimum clearances

18
Risk of crushing from improper installation
• Protect the unit and work area during installation and alignment.
Risk of fire from failure to observe applicable regional fire preven-
tion regulations
• Observe applicable regional fire prevention regulations.
Risk of property damage from overheating of the unit
• Do not install the unit close to heat sources.
Planning drawing
The planning drawing and additional documents can be retrieved from
the manufacturer's page on the Internet (see Legal details) by entering
the number on the unit.
The following clearances from walls, ceilings or other equipment must
be maintained when installing the unit:
• Left, right and rear: at least 50 mm (1,97 in).
B
D
Image: Minimum clearances to walls, ceiling or units
A B
50 (1,97) 100 (3,94)
All dimensions in mm (in)
* Depends on the kitchen ventilation system and quality of ceiling material
Installation instructions
A
C *
---
D
50 (1,97)