Making The Electrical Connection - Henny Penny FlexFusion ELECTRIC SPACESAVER PLUS FSE-610 Installation Manual

Connecting the unit
NOTICE

6.2 Making the electrical connection

26
5. Put the ventilator ring on with the cut-outs facing upwards and
ensure that it can not be rotated.
6. Screw the lid onto the air inlet nozzle.
Removing the unit cover on a built-in unit
a
c
b
a
Image: Removing the unit cover
a Fan
b Seal
c Steam outlet nozzle
1. Unscrew the screws in the unit cover.
2. Carefully remove the unit cover.
Attaching the unit cover on a built-in unit
Risk of property damage from leaky housing
• Check seals when attaching the housing parts.
• Replace damaged seals.
1. Check that the seal on the steam outlet nozzle is seated properly.
2. Apply a film of acid-free lubricant to the seal on the steam outlet
nozzle.
3. Slide the unit cover forward.
4. Carefully position the unit cover flush with the steam outlet nozzle.
5. Install screws in the unit cover.
The unit cover must be in contact with the unit on all sides.
Electrical installation work
Electrical installation work on the electric system and the unit may only
be performed by a specialist company, which is approved by the
electric utility company in the particular region. The applicable regional
Installation instructions
d
e
d Unit cover
e Air diverter