Henny Penny FlexFusion ELECTRIC SPACESAVER PLUS FSE-610 Installation Manual page 29

DANGER
Prerequisite Electrical connection point at installation site dead
INFORMATION
Prerequisite The electrical connection line meets the minimum requirements
Risk of personal injury and property damage from electric shock
• Before connecting, ensure that the electrical connection line is dead.
• Ensure that the electrical connection line is undamaged.
c
Image: Electrical connection line
a Connection terminals
b Electrical connection line
Voltage matches the data on the nameplate
1. Connect the electrical connection line to the connection point at
the installation site in accordance with the circuit diagram.
A suitable connector can also be attached to the electrical
connection line.
2. Complete the start-up operation report.
Connecting the connection line available at the installation site
If a connection line is already available at the installation site, the minimum re-
quirements for the electrical connection line must be observed and complied
with.
Electrical connection line dead
Rear panel removed
Unit cover removed
1. Disconnect the factory connection line and carefully remove it
from the unit.
Note the routing position of the connection line.
2. Pull the electrical connection line into the unit through the cable
gland.
3. Route the connection line so that it corresponds exactly to the
factory routing.
Installation instructions
a
b
c Cable entry
Connecting the unit
29