Henny Penny FlexFusion ELECTRIC SPACESAVER PLUS FSE-610 Installation Manual page 22

Installing the unit
Prerequisite Floor capable of accommodating the weight of the unit
22
Floor must be clean and suitable for the manner fastening
Unit set up and aligned in accordance with the planning drawing
1. Insert the floor plate from the fastening kit into the retainer as
shown in the drawing.
2. Screw on the cap nuts hand-tight.
3. Align the floor fastener in position 1-1 or 2-2 on the unit leg or
underframe as shown in the drawing and mark the fastening holes
on the floor.
4. Mark the position of all unit legs or underframe on the floor.
5. Using suitable lifting equipment, move the unit so that the holes
can be drilled in the floor.
6. Drill holes with a diameter matching that of the anchor sufficiently
deep in the floor.
7. Carefully place the unit in the installation position.
8. Screw on cap nuts and remove the retainer from the floor plate.
9. Using the anchors and fastening screws provided, screw the floor
plate to the floor.
10.Ensure that a tight seal against the floor has been reestablished
after the fastening screws are installed.
11.Place retainer on the floor plate and secure using cap nuts.
12.Complete the start-up operation report.
Floor with steam barrier
In the case of floors with a steam barrier, the floor plates are not
screwed to the floor but fastened with the enclosed adhesive.
A
a
d
c
Image: A: Position of floor plate; B: floor plate glued to the floor
a Cap nut
b Holding plate
c Upright bolt
Installation instructions
B
e
b
d Floor plate
e Unit leg