Table of Contents
Advertisement
5.5
Installing the I/O module (PM)
The CIM is equipped with a receptacle for one I/O module.
Note
The I/O module may only be inserted or removed when the power is off.
Tool
You will need a Torx T8 screwdriver.
Installing an I/O module
The steps for mounting an I/O module are described below:
Figure 5-4
Steps
1
2
3
SIPLUS HCS4300 PROFINET/PROFIBUS DP
Operating Instructions, 10/2019, A5E35452705A/005
Installing an I/O module
Dismantling the blanking cover of the receptacle on the CIM
Insert the I/O module into the receptacle and push it in as far as it will go.
Secure module tightly with screws
5.5 Installing the I/O module (PM)
①
Installing/mounting
51
Advertisement
Table of Contents
