ADEMCO VistaKey-SK Installation & Setup Manual page 80

VistaKey Installation Guide
1. A card's access group is given access to a point in Access Group Programming. Partition
Armed Restriction is not programmed. The following is true:
Card
001
002
003
004
* "Any valid" means that the card is tied to a VISTA user who also has access to the
partition to which the access point is assigned.
2. A card is given access to a point in Access Group Programming. Partition Armed
Restriction is programmed. The following is true:
Card
001
002
003
004
* "Any valid" means that the card is tied to a VISTA user who also has access to the
partition.
To begin #79 Card Function Programming, enter User Code + #79. The following prompt
appears:
Access Point
The "Add Card?" Prompt appears. To add a card or edit a card by using a card swipe, go to
the "Adding Cards" paragraph below. If you do not want to Add a card or edit a card by using
a card swipe, press [0] on the keypad to advance the display to another choice. When the
choice desired is displayed, stop pressing [0] and refer to the corresponding paragraph in this
section for procedural instruction. The order in which the choices are displayed is:
Add Card?
Edit Card?
AUTO Delete?
BLOCK Delete?
MANUAL Delete?
Quit Card Mode?
6–6
Executive VISTA User
Privilege Number
Yes 000
Yes *Any Valid
No 000
No *Any Valid
Executive VISTA User
Privilege Number
Yes 000
Yes *Any Valid
No 000
No *Any Valid
Enter the number (01-15) of the access point (door) for which you
00
want to change card data.
Press [ ] to accept the entry.
Access Through
Access Point if Disarm System
System Armed
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Access Through
Access Point if Disarm System
System Armed
Yes Yes
Yes Yes
No No
Yes Yes