Table of Contents
Advertisement
VistaKey Installation Guide
Assembling and Mounting the VistaKey-SK
To assemble and mount the VistaKey-SK, follow the procedure below:
1. Determine the mounting location for the VistaKey-SK. It must be mounted inside the
protected area near the door strike.
2. Remove the front cover from the VistaKey-SK panel.
3. Mount the Universal Mounting Plate (P/N K4555) in the VistaKey-SK cabinet by sliding
the tabs on the rear of the plate into the 3rd row of mounting points in the cabinet. See
Figure 4-2.
The Universal Mounting Plate is designed so that the tabs will hold it in the cabinet. If desired,
retaining screws (supplied) may be used in the middle 2 holes in the plate to attach the plate to
the cabinet more securely.
4. Position the cabinet on the wall and use the holes in the back of the cabinet to mark your
four mounting holes.
5. Using 4 anchors or fasteners (not supplied), mount the cabinet to the wall.
6. Mount the Power Supply (P/N SA12040) in the VistaKey-SK cabinet by sliding it into the
slots at the top of the cabinet. Secure the power supply using 3 screws, 3 black mounting
spacers, and 1 nylon washer (on the lower-right screw). See Figure 4-3.
Failure to use the nylon washer could result in a ground fault in your fire/burglary system.
Disabling the ground fault indication feature is subject to the local authority having jurisdiction.
4–2
+
+
Figure 4-2: Installing the Mounting Plate
UNIVERSAL
MOUNTING
PLATE
P/N K4555
Hide quick links:
Advertisement
Table of Contents
