General Information; Central Station Reporting - ADEMCO VistaKey-SK Installation & Setup Manual

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In This Section

General Information

Central Station Reporting

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
General Information
This section provides the additional event log entries that are added to the alarm panel when
a VistaKey is connected. Below is a list of the events sent to the central station (CS) and the
events logged into the alarm panel.
Central Station Reporting
The following list contains all additional events that may be reported to the CS. The entires
are grouped by event type. Note that event reporting can be enabled via the Access Dialer
Enables (described in the Programming section of this manual).
ACS Alarms
ACS Troubles
ACS Bypasses
ACS System
Event
Duress Access Grant
Duress Egress Grant
Door Forced Open/Restore
Event
AC Loss at Module/Restore*
Door Propped/Restore
DSM Trouble/Restore
RTE Trouble/Restore
* If a module experiences a loss of power or if the address switch on a VistaKey
module is changed to an improper address, the panel logs an ACLO MOD (AC Loss
Module) event and the AC Loss will be reported. If this event is logged and power is
applied to the module, check that the module's address switch is set to the proper
address.
Event
Access Point Bypass/Restore
Event
Module Reset
Test Entry/Exit
Alarm Panel Logging
Code Specifier
124 User #
125 User #
423 DSM Zone #
Code Specifier
342 DSM Zone #
426 DSM Zone #
427 DSM Zone #
428 DSM Zone #
Code Specifier
577 DSM Zone # (Door Lock Is Open)
Code Specifier
339 DSM Zone # (On Power-up)
607 DSM Zone #
S E C T I O N
Event Log
8–1
8