Table of Contents
Advertisement
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In This Section
General Information
Installing the Equipment
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
General Information
This section provides a brief procedure for the initial installation of the VistaKey module. If
you require more detailed installation information, please refer to the procedures in Section 4
– Detailed Installation. The installation categories described in this section are Installing the
Equipment, Mapping VistaKey Zones to Panel Zones, and Initial System Test.
Installing the Equipment
To mount and connect the hardware required to create an access point, perform the steps in
the following paragraphs.
Mounting and Connecting
1. The VistaKey uses plug-in terminal blocks for TB-1 and TB3. Keeping the terminal block
screws toward the outside edge of the VistaKey printed circuit board, slide the terminal
blocks onto the pins extending from the board.
2. When installing a VistaKey-SK, install the mounting plate into the cabinet, mount the
cabinet, and install the power supply into the cabinet.
IMPORTANT: Use the nylon washer supplied on the lower right power supply mounting
screw.
3. Mount the VistaKey; door strike or mag lock; and card reader.
4. If applicable, mount the Door Status Monitor (DSM) and/or Request-to-Exit (RTE)
devices.
5. Using Figure 3-1 at the end of this section as a reference, connect the card reader
interface cable to TB3, making the +5V or +12V connection last.
6. Connect the leads to VistaKey TB1 in the following order:
a. All ground leads to terminals 2, 5 and 9.
b. The (optional) DSM, RTE, and General Purpose leads to terminals 6, 7, and 8,
respectively.
c. Door strike (or mag lock) lead to the relay pole terminal 10.
d. Local +12V supply lead to terminal 1.
When installing a VistaKey-SK, make this connection from power supply terminal 7.
Quick Installation
Mapping VistaKey Zones for Test
Initial System Test
INSTALLING THE
EQUIPMENT
MAPPING VISTAKEY
ZONES FOR TEST
INITIAL SYSTEM TEST
S E C T I O N
3–1
3
Hide quick links:
Advertisement
Table of Contents
