Table of Contents
Advertisement
VistaKey Installation Guide
Access Control
The access control commands may be used to directly control access points or to add, remove,
or edit cards in the system's cardholder database. The access control commands may be used
as follows:
#73
The #73 command (if enabled for a keypad) may be used to grant entry or exit through an
access point in the partition that the keypad is connected to. The access point will
automatically relatch after the time interval set during system programming. For the #73
command to be accepted, the following conditions must exist.
• The keypad must be attached to the partition where the access point is located.
• If the partition is armed and Armed Restriction is in effect, the user must be authorized to
disarm the partition.
• The user must have access to the partition at the time the command is entered.
• The VISTA user number must be assigned to a card with an access group assignment
which includes the point and partition in which the keypad being used.
• The request will be denied if the access group, that allows the user access to a point, is
disabled.
• The command must have been enabled using the procedures in Section 5: Programming.
Enter the #73 command as follows:
User Code + # + 73
The access point is unlatched for the time period that was defined during system
programming.
#74
The #74 command may be used to grant entry or exit through any access point. The access
point will automatically relatch after the time interval that was set during system
programming. For the #74 command to be accepted, the following conditions must exist.
• If the partition is armed and Armed Restriction is in effect, the user must be authorized to
disarm the partition.
• The VISTA user number must be assigned to the partition to which the keypad belongs.
• The VISTA user number must be assigned to a card with an access group assignment
which includes the point to which access is being requested.
• The VISTA user number does not have to be assigned to the partition to which the access
point belongs to be granted access, but if not, he/she will be denied access while the
partition is armed and an armed restriction has been programmed.
Enter the #74 command as follows:
User Code + # + 74
The following message is displayed on the keypad:
Access Point
00-31
6–2
Enter two digits (from 01 through 15) that corresponding to the
01
access point number where entry or exit is to be allowed.
NOTE: When using the VistaKey, entries between 16 and 31 are
invalid and will not cause any action.
Hide quick links:
Advertisement
Table of Contents
