Section 4 - Detailed Installation; General Information; Installing The Equipment; Figure 4-1: Typical Vistakey Installation - ADEMCO VistaKey-SK Installation & Setup Manual

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In This Section

General Information

Installing the Equipment

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
General Information
This section provides detailed procedures for mounting and connecting the VistaKey-SK or
VistaKey module and related devices. The procedures are for one access point, and should be
repeated for each additional access point being installed. Figure 4-1 illustrates what a typical
installation looks like. The installation categories described in this section are: Installing the
Equipment, Mapping VistaKey Zones for Test, and Initial System Test.
If you have performed the procedures in Section 3 – Quick Installation , bypass this section and
proceed to Section 5 – Programming .
Installing the Equipment
To mount and connect the hardware required to create an access point, perform the steps
provided in the following paragraphs.
Mapping VistaKey Zones for Test
Initial System Test
INSTALLING THE
EQUIPMENT
MAPPING VISTAKEY
ZONES FOR TEST
INITIAL SYSTEM TEST
Entry
Reader
OUTSIDE PROTECTED AREA

Figure 4-1: Typical VistaKey Installation

Detailed Installation
Door Status
Monitor
VistaKey
Door Strike
INSIDE PROTECTED AREA
S E C T I O N
Request
To Exit
4–1
4