ADEMCO VistaKey-SK Installation & Setup Manual page 61

↓ Access Group Number
01 Trace?
NOT ENABLED 0
↓ Access Group Number
01 Restr?1 2 3 4 5 6 7 8
HIT 0-8
↓ Access Group Number
01 Entry Event?
Never Invoke 00
↓ Access Group Number
01 Access Point
(01-15) 01
Press 1 (trace) or 0 (no trace) to define whether the cardholders in
the group are to be traced.
Enabling the trace feature allows this access group to be monitored
by logging entry/exit grants and denials in the alarm panel log
and/or dialing out and sending a report to the central station.
Press [ ] to accept the entry.
Press 0 to toggle Armed Restriction for all VISTA partitions on or
off; or press keys 1-8 (VISTA-128FB) or 1-2 (VISTA-32FB) to toggle
the letter "x" under the Armed Restriction partition numbers on or
off.
NOTE: When the Armed Restriction is enabled for a partition and
the partition is armed, a cardholder will be denied access through
access points in a partition when both of the following conditions
exist:
1. All access groups that the cardholder belongs to have an Armed
Restriction for the partition and none have executive privilege.
2. The cardholder's VISTA User # does not have access permission
for the partition.
Press [ ] to accept the entry.
Enter two digits from the following list for the access point-related
entry event that causes the entry action desired. Acceptable entries
and their meanings are as follows:
00 Never Invoke - causes no action to take place on entry.
02 Access Request (Acs Req) - causes the ENTRY ACTION to
occur when a card swipe occurs on an entry card reader.
04 Any Request (Any Req) - causes the ENTRY ACTION to occur
when a card swipe occurs on an entry or exit card reader.
05 Access Grant (Acs Grt) - causes the ENTRY ACTION to occur
when an access grant occurs on an entry card reader.
07 Any Grant (Any Grt) - causes the ENTRY ACTION to occur
when any grant occurs on an entry card reader.
08 Access Denied (Acs Deny) - causes the ENTRY ACTION to
occur when an access denied occurs on an entry card reader.
10 Any Denial (Any Deny) - causes the ENTRY ACTION to occur
when any denial occurs on an entry card reader.
NOTE: The entry event selected only applies when the card swiped
belongs a member of the access group currently being defined and
the swipe occurs at the access point defined in the following prompt.
Press [ ] to accept the entry.
Enter 1 through 15 for the access point number corresponding to the
entry event defined above.
Press [ ] to accept the entry.
Section 5 - Programming
5–21