Table of Contents
Advertisement
VistaKey Installation Guide
↓ Access Group Number
01 Entry Action?
None
↓ Access Group Number
01 Exit Event?
Never Invoke
↓ Access Group Number
01 Access Point
(01-15)
↓ Access Group Number
01 Exit Action?
None
5–22
Enter two digits defining the entry action desired. For acceptable
entries and their meanings, see Table 5-1: Action Codes; or enter 00
00
for no action. The following rules apply to the selected entry action:
• The action only occurs when the above entry event occurs at the
access point selected and the card triggering the event is assigned
to this access group.
• Actions that arm or disarm partitions are only performed if the
VISTA user assigned to the card is assigned to the partitions
selected.
NOTE: When you use action codes 60 (AP Exit Only), 66 (AP Group
Exit Only), or 72 (AP Partition Exit Only), these actions disable the
entry reader at the access point. The reader will remain disabled
until a command is received (via a keypad command or event) to
protect the access point.
Press [ ] to accept the entry.
In response to the entry action you entered, the system displays a
message asking for additional information, based on the entry
action you selected. For example, if the entry action you selected
was 01 (relay on), the system presents a message asking for a relay
number. Respond to the message and then press [ ] to accept the
entry.
Enter 00 through 10 for the access point-related exit event desired.
Acceptable entries and their meanings are as follows:
00
00 Never Invoke - causes no action to take place on exit.
03 Egress Request (Egr Req) - causes the EXIT ACTION to occur
when a card swipe occurs on an exit card reader.
04 Any Request (Any Req) - causes the EXIT ACTION to occur
when a card swipe occurs on an exit or exit card reader.
06 Egress Grant (Egr Grt) - causes the EXIT ACTION to occur
when an access grant occurs on an exit card reader.
07 Any Grant (Any Grt) - causes the EXIT ACTION to occur
when any grant occurs on an exit card reader.
09 Egress Denied (Egr Deny) - causes the EXIT ACTION to occur
when an egress denied occurs on an exit card reader.
10 Any Denial (Any Deny) - causes the EXIT ACTION to occur
when any denial occurs on an exit card reader.
NOTE: The exit event selected only applies when the card swiped
belongs a member of the access group currently being defined and
the swipe occurs at the access point defined in the following prompt.
Press [ ] to accept the entry.
Enter 1 through 15 for the access point number corresponding to the
exit event defined above.
01
Press [ ] to accept the entry.
Enter two digits defining the exit action desired. For acceptable
entries and their meanings, see Table 5-1: Action Codes earlier in
00
this section, or enter 00 for no action. The following rules apply to
the selected exit action:
Hide quick links:
Advertisement
Table of Contents
