Table of Contents
Advertisement
Peripheral Devices
The below listing identifies some peripheral devices that can be used with the VistaKey.
DEVICE
Card Reader*
Access Cards*
Request to Exit
Door Status Monitor
Power Supply*
Door Strike/Mag Lock Any commercially available electric door strike or magnetic lock
Electric Suppressor*
* These items are included in the VistaKey-SK.
VistaKey-SK Installation Steps
The installation of a VistaKey-SK consists of a few easy steps for hardware mounting and
hook-up, and for programming VistaKey-SK access points via the alarm panel. The steps
required are shown in Figure 1-1: VistaKey Installation Steps.
DESCRIPTION
ADEMCO 5365BGP or any equivalent UL listed prox reader with
comparable ratings.
ADEMCO encoded proxcards with 34-bit format. ADEMCO Part
Number K3399 (set of 25 cards).
Pushbutton contact or motion detector such as ADEMCO 998 PIR.
Contact such as ADEMCO TUFFTACTS® Magnetic Reed Contacts.
Local power supply is ADEMCO part number SA12040.
with a working voltage of 12VDC and a maximum current of 1.5A.
(NOTE: Electric deadbolts are not supported.)
Any commercially available electric suppressor such as the EL-EDS
manufactured by EDCO.
Section 1 – Introduction
1–3
Hide quick links:
Advertisement
Table of Contents
