Table of Contents
Advertisement
After the process has completed, the SMI software shows the found motors in the Configuration
window under the corresponding communications port. Each motor is represented by a motor icon; the
motor's address and firmware version are shown next to the motor icon.
Configuration Window Showing Found/Addressed SmartMotor
Using the Address Motors Feature
This method assumes that there are motors connected to the specified port and will simply address
each one that it finds.
NOTE: This method will address (or re-address) every motor. If you pre-addressed your motors
before connecting them, those motor addresses could be changed by this process.
To use the Address Motors feature, in the Configuration window of the SMI software, right-click the
desired communications port and select Address RS-232 Chain from the menu.
Moog Animatics Class 5 SmartMotor™ Installation and Startup Guide, Rev. I
Using the Address Motors Feature
Selecting the Detect Motors Feature
Page 57 of 76
Advertisement
Table of Contents
Need help?
Do you have a question about the SMARTMOTOR COMBITRONIC and is the answer not in the manual?