Nortel CS 1000 Series Installation And Commissioning Manual page 93

Procedure 31
Perform an ISDN BRI Conference test
Step
The same procedures can be used to test ISDN BRI NI-1 or ETSI Conference.
1
2
3
4
5
6
7
8
9
10
Copyright © 2003-2009 Nortel Networks
.
Action
In the DSL configuration in LD 27, set PRID = 6 to select the
National ISDN-1 protocol, or set PRID = 2 for the ETSI protocol.
In the TSP configuration in LD 27, define conference under
FEATID:
FEATID aaa mmm <nnn>, where
aaa = A03 (3-party conference) or A06 (6-party conference)
mmm = feature activation ID (0 - 127)
nnn = feature indication ID (0 - 127) (If nnn is not entered, it is
assumed
to be the same as mmm)
Select National ISDN-1 or ETSI protocol on the ISDN BRI
terminal if signaling type/protocol is configurable.
On the ISDN BRI terminal, configure Conference. This
procedure largely depends on the implementation of feature key
management on individual terminals. In general:
a The terminal provides Conference as a selectable feature to
be programmed on a hard/soft key. For example, on a soft
key on an M5317TDX, select FA to be FCC; on a hard key on
an M5209TDcp, select CONF.
b The Conference key number selected on the terminal must
correspond to the feature activation ID entered for the TSP
in LD 27.
Configure at least two DN appearances on the ISDN BRI
terminal. On some ISDN BRI terminals, the second DN
appearance allows the user to initiate the second call.
Place an outgoing call from the ISDN BRI terminal.
After the call is established, press the Conference key. The first
call is put on hold automatically; a second key is lit to allow the
user to place the second call.
Place another outgoing call from the second key.
After the second call is established, press the Conference key
again to bridge the two calls. All three parties should be in a
conference.
Press the RELEASE key to drop from the call. The ISDN BRI
user should be disconnected from the Conference; the remaining
Nortel Communication Server 1000
ISDN Basic Rate Interface Installation and Commissioning
NN43001-318 03.01
11 May 2009
Voice calls 93