Nortel CS 1000 Series Installation And Commissioning Manual page 16

16 Installing ISDN BRI hardware
4
5
Procedure 1
Selecting the card slots
Step
To install ISDN BRI cards, perform the following steps:
1
Copyright © 2003-2009 Nortel Networks
.
Install the S/T Interface Linecards (SILCs) and/or U Interface
Linecards (UILCs) or Basic Rate Signaling Concentrators
(BRSCs).
Connect ISDN BRI terminals. This procedure comprises the
following:
•
Connect the system to the Main Distribution Frame (MDF).
•
Cross-connect the MDF.
•
Connect ISDN BRI terminals to the DSL.
•
Initialize the ISDN BRI terminals.
Action
Identify all the slots that can contain the ISDN BRI cards. First
identify the modules with unused network and peripheral card
slots and then remove the covers from the identified modules. To
identify the modules, use the following Print Programs.
•
LD 22 to print the system configuration and identify unused
network card slots to install MISPs
LD 22
REQ: prt
TYPE: cfn
•
LD 20 to list unused IPE card slots to install SILCs, UILCs
and BRSCs
LD 20
REQ: prt
TYPE: luc
TN: l s
Table 2 "ISDN BRI card location" (page 16)
that can house ISDN BRI cards.
Table 2
ISDN BRI card location
Modules
NT4N41
Core/Network Module
Nortel Communication Server 1000
ISDN Basic Rate Interface Installation and Commissioning
NN43001-318 03.01
11 May 2009
--End--
lists the modules
SILCs,
Supported UILCs,
Systems BRSCs
—
Large
Systems
MISPs
Network
slots 0-7