Nortel CS 1000 Series Installation And Commissioning Manual page 55

Configuring ISDN BRI trunking with IP expansion cabinets or Media Gateway systems 55
Table 13 "Hardware requirements for ISDN BRI trunking" (page 55)
the hardware required to configure ISDN BRI trunking.
Table 13
Hardware requirements for ISDN BRI trunking
Hardware
MISP circuit card
SILC circuit card
UILC circuit card
Clock controller
Network termination
Configuring ISDN BRI trunking with IP expansion cabinets or Media
Gateway systems
Configure the MISP card slot number for ISDN BRI trunking in LD 27.
Refer to
27" (page 56)
Configure DSL for ISDN BRI trunking in LD 27. Refer to
responses to LOOP and MISP prompts in LD 27" (page 56)
response to the MISP prompt.
Copyright © 2003-2009 Nortel Networks
.
Product code Description
NTBK22 The MISP card (NTBK22) is specific to Small
Systems. It performs Data Link (Layer 2) and
Network (Layer 3) processing associated with the
OSI protocol.
NT6D70AA -48V North American S/T interface line card
NT6D70BA -40V International S/T interface line card
NT6D71 U interface line card
A clock controller is required in every cabinet or Media Gateway equipped
with a digital trunk card.
NTAK20AB Stratum 3 clock controller daughterboard
NTAK20BB Stratum 4 clock controller daughterboard
Required for conversion from a U to and S/T interface.
ISDN network termination unit (NT1), including NT1
standard power supply. Two cables are provided with
the NT1 power supply unit:
•
•
Table 14 "Correct responses to LOOP and MISP prompts in LD
for the correct response to the LOOP prompt.
Nortel Communication Server 1000
ISDN Basic Rate Interface Installation and Commissioning
NN43001-318 03.01
11 May 2009
178 mm (7 in.) cable for connection between the
power supply and the NT1 unit
captive power cord for connection to an AC power
outlet
lists
Table 14 "Correct
for the correct