Nortel CS 1000 Series Installation And Commissioning Manual page 91

Procedure 29
Performing a Call Forward No Answer test
Step
1
2
3
4
5
6
Calling Line Identification Presentation and Restriction
Calling Line Identification Presentation and Restriction allows a calling
party number (Calling Line Identification) to be shown on a called party
ISDN BRI terminal display. Use LD 27 to specify this feature when
configuring the TSP for the ISDN BRI terminal DN. See "TSP configuration
procedures" in ISDN Basic Rate Interface Feature Fundamentals
(NN43001-580).
Copyright © 2003-2009 Nortel Networks
.
Action
Set the FEAT parameter to FNA and SFA to enable Call Forward
No Answer and Second Level Forward No Answer. (SFA is
needed only to test two levels of Call Forward No Answer.) Use
LD 27 to specify these parameters when configuring the TSP
for one of the two voice ISDN BRI terminal DNs. See "TSP
configuration procedures" in ISDN Basic Rate Interface Feature
Fundamentals (NN43001-580).
Specify the attendant as the forwarding DN using LD 15. At
the FNAL prompt, enter ATT to specify forward to attendant.
Refer to LD 15 in the Software Input Output Administration
(NN43001-611) for more details.
From an ISDN BRI terminal, place a call to the ISDN BRI
terminal with the enabled Call Forward No Answer feature and
the specified call forward to attendant.
Do not answer the call. After a predetermined number of
rings, the call is forwarded to the attendant. The display on the
call-originating ISDN BRI terminal will not be updated to indicate
that the call is modified and forwarded to the attendant.
Verify the call was forwarded to the attendant by answering the
call at the attendant console. The attendant console will display
the call-originating identification number and the notification of
call redirection.
Hang up at the call-originating ISDN BRI terminal to release the
call connection.
Nortel Communication Server 1000
ISDN Basic Rate Interface Installation and Commissioning
NN43001-318 03.01
11 May 2009
--End--
Voice calls 91