Nortel CS 1000 Series Installation And Commissioning Manual page 39

For a successful installation, perform these procedures in the order listed
below:
1.
2.
3.
4.
5.
6.
Selecting the card slots
Follow the same procedures as described earlier for line applications (refer
to Procedure 1 "Selecting the card slots" (page
Removing the module cover for card installation
Follow the same procedures as described earlier for line applications (refer
to Procedure 2 "Remove the module cover for card installation" (page
Installing the MISP
Follow the same procedures as described for line applications (refer to
Procedure 3 "Installing the MISP" (page
Installing the clock reference on the SILC
The DSL#0 and DSL#1 on an SILC card can be configured as the
reference clock source, with DSL#0 being assigned for the primary clock
reference and DSL#1 being assigned for the secondary clock reference.
The loop number and location of the primary and secondary clock source
is configured in the Digital Data Block LD 73. Refer to the ISDN Basic
Rate Interface Feature Fundamentals (NN43001-580).
Providing clock referencing on the SILC
Complete the following procedure to provide clock referencing on the
SILC.
Copyright © 2003-2009 Nortel Networks
.
Select the card slots where the ISDN BRI cards will be located.
Install the MISP.
Install clock referencing on the SILC.
Install the SILC and/or UILC.
Connect the system to the MDF.
Cross-connect the MDF (in Terminal Equipment mode).
Note:
The system, in TIE trunk or CO connectivity, requires a
different wiring configuration than for a line application; the transmit
and receive pairs should be reversed, as illustrated in
"Connect the network termination to the U interface and to the S/T
interface (in TE mode)" (page
Nortel Communication Server 1000
ISDN Basic Rate Interface Installation and Commissioning
NN43001-318 03.01
11 May 2009
Installing ISDN BRI hardware for trunk applications 39
44).
20)).
Figure 12
16)).
20)).