Nortel CS 1000 Series Installation And Commissioning Manual page 57

5
6
7
8
Copyright © 2003-2009 Nortel Networks
.
Install the SILCs and UILCs. See
SILCs and UILCs" (page
Remove the SILCS and UILCs, if previously installed. See
Procedure 18 "Removing the SILC and UILC" (page
Install the PRI hardware. See
hardware" (page
Note: This step is required for packet data implementation
only.
Connect the ISDN BRI terminals or trunks.
a Connect the ISDN BRI terminals for line applications:
1. Connect system cables to the cross-connect terminal.
See Procedure 20 "Connecting system cables to the
cross-connect terminal" (page
2. Cross-connect the DSLs at the cross-connect terminal.
See Procedure 21 "Cross-connecting the DSLs at the
cross-connect terminal" (page
3. Connect the terminating resistor to the SILC DSL. See
Procedure 22 "Connecting the terminating resistor to the
SILC DSL" (page
4. Connect the ISDN BRI terminals to the DSL. See
Procedure 23 "Connecting the ISDN BRI terminals to the
DSL" (page
5. Initialize a Nortel Networks M5317TDX terminal. See
Procedure 24 "Initializing a Nortel Networks M5317TDX
terminal" (page
b Connect the ISDN BRI trunks for trunking applications:
1. Connect the system cables to the cross-connect terminal.
See Procedure 25 "Connecting the system cables to the
cross-connect terminal" (page
2. Cross-connect the DSLs at the cross-connect terminal.
See Procedure 26 "Cross-connecting DSLs at the
cross-connect terminal" (page
Nortel Communication Server 1000
ISDN Basic Rate Interface Installation and Commissioning
NN43001-318 03.01
11 May 2009
Procedure 17 "Installing the
60).
Procedure 19 "Installing the PRI
63).
73).
76).
79).
--End--
Installation procedures 57
63).
65).
69).
81).
82).