Nortel CS 1000 Series Installation And Commissioning Manual page 23

1
2
Procedure 7
Connecting ISDN BRI terminals to the system
Step
To connect the ISDN BRI terminals to the system, perform the following steps.
1
2
3
Figure 5 "Connect the ISDN BRI terminals to the Large System" (page
24)
modular cables.
Copyright © 2003-2009 Nortel Networks
.
Hold the card by its card-locking devices. Squeeze the tabs to
unlatch the card-locking devices and lift them away from the
card.
Carefully disengage the BRSC, SILC, or UILC from the
backplane connector, and slowly slide the card from the module.
Action
Connect the system to the MDF.
Cross-connect the MDF.
Connect the ISDN BRI terminals to the Digital Subscriber Line
(DSL).
shows a typical DSL with ISDN BRI terminals connected to it using
Nortel Communication Server 1000
ISDN Basic Rate Interface Installation and Commissioning
NN43001-318 03.01
11 May 2009
Installing ISDN BRI hardware for line applications 23
--End--
--End--