Nortel CS 1000 Series Installation And Commissioning Manual page 80

80 Configuring ISDN BRI hardware
24
25
26
27
28
Table 19
M5317TDX terminal error codes
Error Code
Connecting the ISDN BRI trunks (for trunking applications)
For trunking applications, two procedures are required to connect the ISDN
BRI trunks:
Copyright © 2003-2009 Nortel Networks
.
Press EDIT DN then use the keypad to enter the digits of the
DN.
Press OK then SAVE after each DN.
Repeat step 18
Press INSTALL and begin at
data. If the entries were correct, press EXIT.
Make a voice call to make sure the telephone is operational.
Number Description
>>10<< S/T-loop sync loss and/or Frame sync loss.
>>11<< L1 transmit timer expired.
>>21<<
Voice TEI removed by network.
>>22<< Circuit data TEI removed by network.
>>23<< Voice and circuit data TEI removed.
>>24<<
X25 TEI removed.
>>25<<
Voice and X25 TEI removed.
>>26<< Circuit data and X25 TEI removed.
>>27<<
All TEI removed.
>>28<<
Voice link not established.
>>29<< Circuit data link not established.
>>2A<< X25 link not established.
>>2B<< No Layer 2 link established.
>>30<< No Layer 3 link established.
>>31<<
No valid voice SPID.
>>32<<
No valid data SPID.
>>90<< Restricted power mode in use. Lower ringer and speaker
phone volumes apply.
Nortel Communication Server 1000
ISDN Basic Rate Interface Installation and Commissioning
NN43001-318 03.01
11 May 2009
to step 25 for each voice DN keypad you want.
step 4, If you entered incorrect
--End--