Nortel CS 1000 Series Installation And Commissioning Manual page 66

66 Configuring ISDN BRI hardware
2
3
4
5
6
Copyright © 2003-2009 Nortel Networks
.
connectors in main cabinet" (page
connectors in the second expansion cabinet" (page
Connect an NE-A25B cable to each connector associated with
a card slot containing a SILC or UILC circuit card. See
20 "Cable connectors in main cabinet" (page 67)
21 "Cable connectors in the expansion cabinet" (page 67)
Figure 21 "Cable connectors in the expansion cabinet" (page
67) and Figure 22 "Cable connectors in the second expansion
cabinet" (page 68)
connectors" (page 68)
cable connectors" (page
Tag both ends of each cable with the cabinet or Media Gateway
connector numbers.
Connect the cables to the connectors at the bottom of the
cabinet or at the rear of the Media Gateway.
Replace the retaining bar when you connect all the cables to the
system.
Terminate the 25-pair cables at the cross-connect terminal.
Label the cross-connect terminal for each connector (UILC or
SILC).
Figure 24 "SILC port designation label at the cross-connect
terminal" (page 69)
the cross-connect terminal" (page 69)
designation label at the cross-connect terminal" (page 69)
the label used with the BIX cross-connecting system.
Note: Use of the BIX cross-connect system is not mandatory.
The system supports other cross-connect equipment. Refer to
the documentation provided with your cross-connect system
for further information.
Nortel Communication Server 1000
ISDN Basic Rate Interface Installation and Commissioning
NN43001-318 03.01
11 May 2009
67), and
and Figure 23 "Back of Media Gateway cable
on Figure 23 "Back of Media Gateway
68).
and Figure 25 "UILC port designation label at
on
--End--
Figure 22 "Cable
68).
Figure
and Figure
on
Figure 25 "UILC port
show