Nortel CS 1000 Series Installation And Commissioning Manual page 20

20 Installing ISDN BRI hardware
Procedure 2
Remove the module cover for card installation
Step
To remove the covers from the modules with unused card slots, follow the
procedure below. Refer to
1
2
3
4
5
6
Figure 4
Module cover locking latches
Procedure 3
Installing the MISP
Step
Once covers have been removed and card slot locations selected for ISDN BRI
cards, install the MISP cards.
Copyright © 2003-2009 Nortel Networks
.
Action
Figure 4 "Module cover locking latches" (page
Use a flat-blade screwdriver to unlock the left latch on the front of
the cover by turning the screw 1/4 turn clockwise.
Use a flat-blade screwdriver to unlock the right latch on the front
of the cover by turning the screw 1/4 turn counterclockwise.
While holding the cover so it does not fall off, slide the latches
toward the center of the cover.
Pull the cover toward you and lift it away from the module.
Place the cover in a safe place away from the working area to
avoid damaging it.
Repeat steps 1 through 5 for each cover requiring removal.
Action
Nortel Communication Server 1000
ISDN Basic Rate Interface Installation and Commissioning
NN43001-318 03.01
11 May 2009
--End--
20).