Nortel CS 1000 Series Installation And Commissioning Manual page 101

Procedure 38
Perform a D-channel packet data transmission test using an external packet
handler
Step
1
2
3
Procedure 39
Perform a D-channel Switched Virtual Circuit packet data transmission test
using an MPH
Step
1
2
3
4
5
Copyright © 2003-2009 Nortel Networks
.
Action
From an ISDN BRI D-channel packet data terminal, dial another
ISDN BRI packet data terminal and establish an active call
connection.
After the call-originating ISDN BRI terminal receives an
acknowledgment that the receiving ISDN BRI terminal is
ready, the call-originating ISDN BRI terminal can begin
transmitting packet data.
Verify that the transmitted data is received successfully by
checking the transmitted information for accuracy. Read the
information on the screen or print it on the local printer.
Release the connection.
Action
From an ISDN BRI D-channel packet data terminal, dial another
local ISDN BRI packet data terminal or a remote packet data
terminal (depending on how you have configured your MPH
application). Establish an active call connection.
After the call-originating ISDN BRI terminal receives an
acknowledgment that the receiving ISDN BRI terminal is ready,
the call-originating ISDN BRI terminal can begin transmitting
packet data.
Verify that the transmitted data is received successfully by
checking the transmitted information for accuracy. Read the
information on the screen or print it on the local printer.
Perform this test between two ISDN BRI terminals on the same
MPH for local transmission and between a system ISDN BRI
terminal and a remote ISDN BRI terminal over the Packet
Switched Data Network (PSDN).
Release the connection.
Nortel Communication Server 1000
ISDN Basic Rate Interface Installation and Commissioning
NN43001-318 03.01
11 May 2009
Packet data transmission 101
--End--
--End--