Inserting Media Modules - Avaya G250 Installation And Upgrade Manual

Inserting media modules

After you have inserted the S8300B Media Server module, if applicable, insert the rest of the
media modules. Make sure to insert each module in a permissible slot. For information about
which slots to allocate to which modules, see
!
CAUTION:
Hold media modules only by the edges to avoid damage from static electricity. Do
CAUTION:
not touch the top or bottom of the circuit board. If possible, wear a wrist-strap and
use an anti-static bag.
!
CAUTION:
The connector pins can be bent or damaged if the module is handled roughly, or
CAUTION:
if misaligned and then forced into position.
!
CAUTION:
Separate ESD paths to the chassis ground connect to the media modules at the
CAUTION:
spring-loaded captive screws. Use a screw driver to ensure the captive screws
are securely tightened to prevent damage to the equipment.
To insert a media module:
1. Remove the blank plate from the empty bay.
2. Position the media module before the selected bay on the front of the G250 chassis and
engage both sides of the module in the interior guides.
3. Slide the module slowly into the chassis, maintaining an even pressure to assure that the
module does not become twisted or disengaged from the guides.
Figure 6: Inserting a media module
Step 2: Install the media modules
Allocating slots on page 34.
Issue 1.1 June 2005 37