Inserting Media Modules - Avaya G250 Installing And Upgrading

6. Lock the S8300 Server module into the chassis by tightening the spring-loaded captive
screws on the front of the module.
7. If you are installing an S8300A or S8300B, replace the plate labelled "Remove before
removing or inserting S8300 module" above slot V1, and tighten the screws on the front of
the plate.
!
DANGER:
To prevent access to electrical hazards by unauthorized personnel and to ensure
DANGER:
continued compliance to radiated emissions requirements, all captive screws
must be securely tightened such that they cannot be loosened without the use of
a tool.

Inserting media modules

After you have inserted the S8300 Server module, if applicable, insert the rest of the media
modules. Make sure to insert each module in a permissible slot. For information about which
slots to allocate to which modules, see
ELECTROSTATIC ALERT:
Hold media modules only by the edges to avoid damage from static electricity. Do
ELECTROSTATIC ALERT:
not touch the top or bottom of the circuit board. If possible, wear a wrist-strap and
use an anti-static bag.
!
CAUTION:
The connector pins can be bent or damaged if the module is handled roughly, or if
CAUTION:
misaligned and then forced into position.
!
CAUTION:
Separate ESD paths to the chassis ground connect to the media modules at the
CAUTION:
spring-loaded captive screws. Use a screw driver to ensure the captive screws
are securely tightened to prevent damage to the equipment.
1. Remove the blank plate from the empty bay.
2. Position the media module before the selected bay on the front of the G250 chassis and
engage both sides of the module in the interior guides.
3. Slide the module slowly into the chassis, maintaining an even pressure to assure that the
module does not become twisted or disengaged from the guides.
Allocating slots on page 31.
Step 2: Install the media modules
Issue 6 November 2009 33