Adding a LAN device
Adding a LAN device requires you to do the following tasks:
Connect the LAN device
●
Configure the LAN device on the G250
●
Test the LAN device
●
Connect the LAN device
To add a new LAN device, see one of the following sections:
Connecting a switch or a network data port
●
Connecting a computer
●
Connecting a server
●
Configure the LAN device on the G250
Before software configuration for the new LAN device takes place, gather the following
information:
the name and location of the owner of or person responsible for the LAN device
●
the slot and port number on the Avaya G250 Media Gateway to which the LAN device
●
connects. If the LAN device is connected to an IP telephone, note the extension of the
telephone to which the LAN device connects, and the slot and port number on the G250 to
which the telephone connects.
Configuration may be performed on site by connecting a laptop computer connected to the
CON port of the G250, or remotely via a modem connected to the G250 or S8300B. For
information about preparing a modem, see
remote access
G250
on page 65.
Test the LAN device
After installation and configuration of the LAN device is complete, ping the IP address of the
device to test the device's connectivity within the network and outside the network.
on page 44
on page 44
on page 51. For information about configuration, see
on page 44
Chapter 5: Connecting and enabling a modem for
Adding a LAN device
Chapter 6: Configuring the
Issue 1.1 June 2005
73