Mobotix D16 DualDome Manual page 45

First Installation Steps
5. Insert the MicroSD card : Push the MicroSD card as
shown (electrical contacts pointing toward the dome)
into the card slot using a tweezers. Make sure that you
hear a click when the card is inserted. The card is now
locked and can be used. If a new MicroSD card is used,
it must be formatted before use (see Section 3,
«Operating the Camera»).
6. Install cable cover : Push the cable cover back into its
seat and fasten the two M4x25 Allen screws. When
mounting the cable cover, take care to properly align
the cover with the seal of the camera housing and the
two cable guides. This is the only way to ensure that
the connections are reliably protected against any kind
of weather.
7. Attach the outer shell : Hold the outer shell so that
the round hole of the shell is positioned over the PIR
sensor of the camera. Gently press the shell into the
shell's seats in the camera housing. Old outer shells
(D10D, D12D) may no longer be used!
Max. tightening torque of
the Allen screws: 1 to 1.2 Nm
45