Mobotix D16 DualDome Manual page 81

Image Optimization
Using the OnScreen Control:
Horizontal image panning
Vertical image panning
Select image sensor: The two rectangular checkboxes in the top right corner display which
sensor image is currently selected and can be configured. You can change the selection by
repeatedly clicking the checkbox symbol:
• Both sensor images selected
• Only left sensor image selected
• Only right sensor image selected
Zoom in on image(s): You can change the zoom factor by clicking the respective magnifying glass
symbol in the range. The effect is greater the further you click from the center of the range. You
should be able to zoom until, on the one hand, the cushion-shaped borders caused by the distor-
tion correction disappear (
ZOOM -
image are visible (
Move image(s) vertically: You can move the selected sensor image up or down by clicking on the
arrows pointing upwards and downwards in the range. The effect is greater the further you click
from the center of the range.
Move image(s) horizontally: You can move the selected sensor image to the left or right by clicking
the arrows pointing left and right in the range. If both sensor images are selected simultaneously,
they can be moved away from one another by clicking the left side of the range and towards one
another by clicking the right side of the range.
Rotate image(s): You can rotate the sensor images to the left or right individually or together syn-
chronously by clicking the edges of the rectangles on the bottom of the range. This way, you can
correct any offset in the lens mounts.
ZOOM +
) and on the other hand, the objects in the vertical center of the
).
Image sensor selection
Zoom
Rotate
Clicking the central point
of the dial resets the image
to the corresponding
factory default settings
81