Outdoor Installation On A Wall, Pole Or Corner (With Accessories) - Mobotix D16 DualDome Manual

Overview of Mounting Options
Special Case: D16-Panorama/180° Mounted to a Wall without the Wall Mount
The lens mount unit has to be rotated by 180° so that you do not get an upside down panorama
image. For further information, see the end of Section 2.3.1, «Mounting Sensor Modules».
Make sure that the camera is always mounted on a smooth surface . Otherwise, the
sealing lip on the underside of the housing will not be able to close tightly or will bend
upwards, which leads to leaks between the outer shell and the housing.

2.1.2 Outdoor Installation on a Wall, Pole or Corner (with Accessories)

The associated Outdoor Wall Mount can be used to mount the D16 outdoors. The camera
is then compliant with the IP65 protection class (fully dustproof and resistant to water jets).
Ambient temperatures may vary between –40 to 60 °C/–40 to 140 °F, making it the ideal
camera for the most demanding weather situations. The drill holes must be prepared for
the installation. Use the supplied drilling template to mark the position of the holes for the
fixtures and the holes through which the cables will be led later on (fold-out).
If you would like to mount the MOBOTIX D16 to the corner of a building or to a pole, you should
consider using the MOBOTIX Corner And Pole Mount. This mount can only be used together with
the Outdoor Wall Mount. The supplied stainless steel straps allow the mount to be attached to
poles with diameters between 60 and 180 mm.
Note
The folded drilling tem-
plates can be found at
the end of the manual
When printing, make sure
that the drilling template
is printed in its original
size (is neither enlarged
nor reduced in size)
Make sure that the arrows
are pointing upwards
when mounting
31